Edwardsville Concrete
Mon–Fri: 8 AM–9 PM, Sat–Sun: 6 AM–9 PM(618) 800-9951Request an estimate

Concrete floor installation in Edwardsville IL - a finish that fits how you use it

Old floor cracked, dusty or uneven, or a new room that needs one? We pour a floor with the base, barrier and finish your room calls for.

Stone-faced concrete steps with black cable railings lead to a raised house entrance and stamped patio.

What does a new concrete floor in Edwardsville involve?

Concrete floor installation in Edwardsville is the whole job of putting down a new slab floor, from digging out and packing the ground to setting forms and steel, then pouring and finishing it, so you end up with a finished floor or a solid base for tile, wood or carpet.

Most floor calls come from a garage or shop, a new addition, a basement or an old slab that's cracked, sinking or chipping. At Edwardsville Concrete, the job starts underneath with the subgrade, the ground the slab sits on, dug out and packed firm so it doesn't settle with the dirt. Then come forms, rebar or mesh, the steel inside that helps hold the slab together, and the pour.

The price mostly follows the floor's size, how much digging and base work the ground needs, whether it gets a moisture barrier, and the finish you pick. The schedule turns on the weather and the permit side, which we check with the local office for your address before we start. Your estimate spells out what we'll pour and how, and if the floor needs concrete steps up to a door, we can plan those too.

Concrete floor choices to settle first

Most of what makes a floor last gets decided before the truck shows up, so here's what we talk through with you before anything gets poured.

  • Smooth or textured

    Repeated passes with a steel trowel leave a smooth floor that gets slippery when wet, so a room that sees water needs a different finish, much like a concrete pool deck.

  • Floors going under flooring

    A floor that'll be covered with tile, wood or carpet doesn't need the smoothest, hardest surface, so we match the finish to what you plan to lay on it.

  • A barrier with no holes

    A covered floor gets a moisture barrier underneath, and one barrier maker says even small holes can sharply raise the moisture coming up and lead to flooring failures.

  • Base before finish

    The packed base disappears on day one, so it's the first thing people want to trim. I'd spend there first, because a pretty finish on a soft base just cracks prettier.

Concrete floor questions we hear

Will my new concrete floor crack?

Some hairline cracking, yes, because even a well-designed, properly built floor won't stay completely free of cracks and slight curling at the edges. I'll tell you that up front. What we can do is cut control joints, shallow grooves that give the slab a straight place to crack, so the cracks mostly land where we chose.

How much does a concrete floor cost in Edwardsville?

Installing a cement slab usually runs about $10.50 to $12.50 per square foot across the US, and that's a national average for the slab put in, not our price. What yours costs depends on the size, the base work, any barrier or steel and the finish. I come out, measure and put our number in writing in plain words.

Can a concrete floor be poured in winter in Edwardsville?

Yes, with the right steps, which cold-weather guidance lists as warming the base, clearing any frost and keeping the new concrete warm with blankets or heaters. Fresh concrete can freeze in its own water while it's still weak, and that's the reason for all of it. Ask any crew how they'll keep the slab warm, and if the weather says wait, I'd rather tell you that than rush it.

Who answers permit and code questions for a concrete floor in Edwardsville?

Your city, village or county code official does, and inside Edwardsville building permits go through the city's Public Works office. The city's list names remodeling and new buildings, like additions, moved walls, plumbing and wiring, but doesn't name concrete floors, so we check with the office for each address, handle the paperwork our work needs and set up inspections as we go. In unincorporated Madison County, the contractor applies for a building permit with plans before starting, and an inspector checks the work at set stages.

What causes a new concrete floor to dust or flake?

Finishing the top too early is the usual cause, while bleed water, the water that rises to the surface after the pour, is still coming up. That leads to dusting, flaking, fine surface cracks and blisters later on. I'm on site when we pour, so the timing of the finishing is on me.

How do I get paint or a coating to stick to a new concrete floor?

Tell your contractor before the pour, because some curing compounds can keep paint from sticking well. Those are coatings sprayed on during curing, the stretch when the slab is kept moist so it gains strength before you use it. Ask that the compound's maker confirm it suits a floor you plan to paint or coat.

Why Edwardsville homeowners call Edwardsville Concrete for floors

You'll deal with me from the first visit to the final walk-through, whether your floor is in Edwardsville or the cities around it on both sides of the river, in Illinois and Missouri.

  • The owner writes your estimate

    I come out myself, measure the room and write the estimate in plain words.

  • The owner at your pour

    I'm on site with our crew when we pour, so the finishing and the joints get watched.

  • Based in Edwardsville since 2023

    I started this business here in 2023 after learning concrete one pour at a time.

  • Licensed and insured

    We're licensed and insured, which is worth asking any contractor before they dig on your property.

  • Satisfaction guaranteed

    Satisfaction guaranteed on every job, so call (618) 800-9951 or send the form to set up a visit.

Talk through your new concrete floor

A floor is a lot easier to change on paper than after the pour, so call (618) 800-9951 or send the form.

What happens when you call about a concrete floor?

Every floor gets planned around how you'll use the room and what's going on top of it, with me on the job from the first look to the walk-through.

  1. You get in touch

    Call (618) 800-9951 or send the form, and we get back to you to set up a time for me to come out.

  2. I come out

    I measure, look at where water goes and what's around the spot, and ask how you'll use the floor before we talk finishes.

  3. Your written estimate

    You get it in plain words, saying what we'll pour and how, from the base and any barrier or steel to the finish.

  4. Prep, pour and walk-through

    Once you say yes, we check the permit side with your local office, get utilities marked, prep, pour, cure it right and walk the finished floor with you.

(618) 800-9951

Call (618) 800-9951